V6 ECU (Me9.6) anti-vibration kit

€ 17,95

The V6 ECU of the Saab 93 is plagued by 1 major problem: Vibration. Where the T8 ECU of Saab is made of a flexible printed circuit board material, the V6 ECU of the Saab 93 is made of ceramic. Ceramic and the associated heat-resistant silicone substance that is covered over this circuit board protect the ECU well against the bizarre temperatures of the 2.8V6.

The only thing where the protection unfortunately falls short is vibration. Especially when the Saab 93 2.8V6 is driven vigorously, despite the fine balance that this engine has, a lot of light vibrations can be transmitted to the ECU.

However, the anti-vibration kit ensures that these vibrations are partially nullified. The reduction in vibrations that the ECU achieves is approximately 30-40% (depending on both the engine room temperature and the outside temperature, in addition: the warmer, the more vibration is absorbed).

The ME9.6 anti vibration kit ensures that the ECU lasts longer, but this is also arbitrary because. Suppose your ECU would fail tomorrow without this kit, then that will be extended by half a day at most if you are lucky.

But for cars that are not or hardly driven and that are only used as the ultimate cruise Saab. Then this product works perfectly. The Saab 93 V6 anti vibration kit consists of:

  • 4x Vibration damper
  • 4x M6 18mm screws
  • 1x 55cm ground cable (if necessary).

Note that the bracket that you see in the picture is already mounted on your car, the vibration dampers are an add-on kit that will fit on the original bracket.